The IP address of the gateway is the IP address of the device with a routing function, such as a router or a server that enables the routing protocol. So the PC0 gateway should be 192.168.1.3, as for your switch vlan1 with IP, in the actual work for the management of IP.

The default gateway command is the layer 2 equivalent of a layer 3 default route. You provide the default gateway as the management interface SVI on SW1 or SW4 based on where in the network you are located. On SW2 and SW3 you will put ip default-gateway 192.168.100.1. On SW5 and SW6 you will put ip default-gateway 172.168.100.1

2010年10月17日 · A. ip default-network 192.168.12.1 (Does not set the gateway to 192.168.12.1... with "ip default-network", it just means that if a Switch has a route to that network i.e. 192.168.12.0/24 (it is a classful command), then that route is flagged as a candidate default route... so this cannot be the right answer as it actually does not set the ...

The "ip default-gateway x.y.z.w" command is necessary in a Layer 2 switch to management remotely. Without this command, you can't access by telnet/ssh . On Cisco press. Configure the Default Gateway. The switch should be configured with a default gateway if the switch will be managed remotely from networks not directly connected.

The ip default-gateway defines where the switch should forward traffic that is destined outside its local network. The command is very similar to how default gateways function on regular hosts. In your scenario, Telnet to 192.168.10.2 to access the switch. The default gateway address should reflect the interface IP address configured on the ...

IP addess of the Domain controller: 10.0.0.10 255.255.255.0 but the default gateway is 10.0.1.1 . If the default gateway has 10.0.0.1 it will fall under the same subnet since the ip range will be 10.0.0.1 -10.0.0.255 . But here it is the default gateway falls under the subnet 255.255.254.0 .....

(Default gateway is the same as default route.) The default gateway can be set in a number of different ways, and the easiest way is to just configure it statically using the command ip route 0.0.0.0/0 x.x.x.x where x.x.x.x is the IP address of the next-hop. The reason that a default gateway is very important is that it keeps the traffic going.

The hosts on the network only use the switch for Layer 2 purposes. But we, the administrators need IP (and more specifically a default gateway) for remote management. We know that with IP we need 3 things to communicate on an inter-network: IP …

as was stated above, "the default-gateway is merely used for management of an l2 switch", meaning that other devices on the network will be able to access it remotely for management purposes, ie, using telnet or ssh if configured, but this ip default-gateway is not necessary to forward traffic...

In other words, the ip default-gateway is the gateway only for the switch itself. The one configured via ip route 0.0.0.0 0.0.0.0 is the default gateway for the switch AND for traffic routing through it.