2024年3月6日 · Sorry 2025R here but hydraulic pump and such is probably all the same as the 1025R right? Tested mine near idle and factory setting is just under 2000psi. 2022 2025R TLB - 120R loader; 260B backhoe; 60" Quick-hitch front blade; Frontier BB2048 box blade, Frontier MG20F Mechanical Grapple; Frontier RC2048 Brush Hog

2024年7月18日 · I recently checked the hydraulic pressure at the SCV and found it about 1800psi. I adjusted it up to what I understand is the upper limit of the design specs for the tractor - 2000psi +/- 150 - so I'm at about 2100-ish. I haven't tested it yet - but it looks like the hydro circuit for the SCV is separate from the 3-point.

2023年7月10日 · While you are checking it, you might want to tweak the hydraulic pressure a little. Usually comes from factory around 2000 psi give or take a bit. A lot of us 2025R owners have bumped ours up to 2500 psi and some to even 3000 psi. 2500 seems to be the sweet spot. You will notice a huge improvement in front and rear lift capacity.

2019年8月31日 · A simple tool invented (and patented) by George Waite makes releasing pressurized hydraulic couplers as easy as turning on a water faucet. Waite's Hydraulic Pressure Relief Tool works like pliers to grip the valve end. Turn a simple tap on one side of the pliers, and it slowly presses on the male fitting, gradually releasing pressure as needed.

2019年10月6日 · I am not sure what the pressure is supposed to be but I will share that my dealer checked my Gen 2 2025 and the work order says, Checked Hyd Pressure Its At 2490 PSI Spec Is 2421 +/- 70. Hyd Pressure Within Spec. FWIW

2023年12月14日 · If you hold it in neutral, jimmy it in neutral, or put it in full down, maxing out another function will get the squeal and pressure loss. Hydraulic Pump Inlet Suction Screen/Filter. I pulled that, it certainly wasn't clean but it wasn't plugged. I cleaned the Suction Strainer, replaced the filter and hydraulic oil with JD Low Viscosity Hygard.

2020年3月4日 · Make sure you warm the hydraulic fluid per the test instructions prior to taking any pressure readings. 2012 2720 -- 200CX Loader -- 54" Quick Attach Snow Blower -- Frontier LR5060 Rake -- Land Pride RB1660 Blade (Hydraulic Angle) -- Artillian 42" Forks -- Ken's BOGH -- 2013 X500/48 for mowing duties.

2020年6月22日 · I found that turning the engine off, then turning the key to accessory, then activating the “joystick” controls eliminates the hydraulic pressure allowing the fittings to be released. 2019 3033R. Frontier boxblade, 3pt grader blade, landscape rake, pallet forks, 72” rotary cutter, root grapple, Wallenstein logging winch, Woodland Mills 6 ...

2022年2月1日 · What sort of gauge and fittings do I need to check the pressure? And recommendations you have are most welcomed. 2021 2032R, 220R loader with single point connector, factory 3rd function, dual rear SCV with top and tilt kit, Hydros Plus hydralic pump.

2023年10月23日 · 2025r 2nd gen hydraulic pressure Jump to Latest 1.8K views 4 replies 2 participants last post by hvw Oct 23, 2023